How to make paper flowers by hand origami is simple and beautiful.

The simple and beautiful answer about how to fold small flowers is as follows: Method 1: Select five square cardboard sheets with the same size and fold them separately: fold them diagonally to form a triangle, and then fold the two corners of the triangle upwards. Then open the two sides, fold the top, fold the triangle in half, and then stick it with glue. Other folding methods are the same. After folding, glue them one by one, and then trim the edges with scissors. A lovely little flower is folded, simple and beautiful. Method 2: First, prepare two pieces of colored paper, a square and a rectangle, and then prepare a pair of scissors. Second, fold one corner of the square in half to make a triangle. Third, fold the corners on both sides of the triangle upwards and turn them into tulips. Fourth, fold the four corners of the rectangle to the middle. Fifth, fold the four sides in half to the middle. Sixth, fold the left half to the right. Seventh, turn the lower corner from the inside up and fold it into leaves. Eighth, cut a small tip from the corner below the flower with scissors. Ninth, insert the tip of the tulip into the hole under the flower and the tulip will fold. Method 3: Step 1: First, I prepare a square origami, and the paper should not be too soft. Step 2: Fold the square origami we prepared in half, pay attention to align each side, we get a rectangle, and then flatten it. Step 3: Fold the rectangle we just got in half again, and then flatten it. Step 4: unfold the figure completely, and we can see that the two creases cross horizontally and vertically. Step 5: Based on the two creases just obtained, fold one corner of the square origami towards the center point and align it with the center point. I have a square. Step 7: Turn the just folded graph upside down. Step 8: Fold one corner of the square just obtained to the center point, align it with the center point, and then flatten it. Step 9: Fold the other three corners of the square towards the center point, align them with the center point and flatten them, as shown in the figure. We get a smaller square. Step 10: Fold one corner of the small square origami just obtained to the center point, align it with the center point, and then flatten it. Step 11: Fold the other three corners of the square origami towards the center point, align with the center point and flatten it. Step 12: Turn the just folded graph upside down. Step 13: Open the four corners outward. Step 14: Squeeze the figure into the middle and flatten the small one in the middle.