How to disassemble the shell of Vantage water heater?

1, turn off the power first. 2. There is a small hole above the side plate of the water heater, which can be sealed with a rubber pad, and then slowly press it down along the edge with a screwdriver to take out its rubber pad. 3. After the rubber pad is pulled out, a screw will be exposed, and the screw will be unscrewed counterclockwise. 4. After that, you need to fasten the cover of the thermostat knob, gently pry it up along the edge of the thermostat knob with a screwdriver until the cover is pried up for a certain distance, and then pull it out by hand.

Expand:

1, the screw is special, and you need a triangular screwdriver to screw it in. You can also take a flat screwdriver and narrow the width of the flat screwdriver with a grindstone until the triangular screw can be completely inserted.

2. After removing the cover, you can see two cruciform screws, and unscrew them slowly with a screwdriver, so that all the screws on the side plate can be removed. Finally, press both sides of the side plate with both hands, rotate horizontally clockwise and remove the side plate.

3. The water heater should be inspected at least once a year, and its safety performance and other possible hidden dangers should be carefully detected and eliminated; When the water heater is used normally, the thermostat and heater should be replaced at the designated maintenance point every three years, and the expired water heater should be replaced in time. The inner tank needs to be cleaned once every six months to discharge the water and sediment in the water heater.