How to debug the electric pressure cooker

1. You can use a small screwdriver with a blade width of about 1.8 to 2.5mm to buckle it on the adjusting screw of the pressure switch and turn it clockwise. Wait until a click indicates that the switch contact has been disconnected, and then rotate counterclockwise. When the "click" sounds again, it means that the contact is completely closed. Continue to adjust the screw for 3 to 4 turns.

2. Add a proper amount of clean water to the electric pressure cooker, and the amount of clean water should be higher than the minimum water level control line. Then close the cover of the electric pressure cooker, set the pressure-limiting air release valve, and check whether the float will fall.

3. Turn on the power of the electric pressure cooker and heat it. After the float rises, water vapor emerges from the valve port and makes a "filar silk" sound, cutting off the power supply. At this point, adjust the adjusting screw of the pressure switch clockwise, and stop the adjustment after the "click" sound appears. Then, when there is slight steam coming out of the vent valve, it can be turned into a pressure maintaining state, and the adjustment is over.

Second, what should I pay attention to when using an electric pressure cooker?

1, when using the electric pressure cooker for the first time, you should pay attention to the details according to the instructions, and try not to use it at will, so as not to cause details problems and damage the electric pressure cooker.

2. Before using the electric pressure cooker, be sure to check whether the exhaust hole is unobstructed. If it is blocked by food, it needs to be dredged to facilitate normal use. Moreover, it is necessary to check whether the sealing ring is aging, which will affect the normal use and need to be replaced in time before use.