How to set shape boundaries in AutoCAD20 10

Many friends use AutoCAD20 10, but they don't set graphic boundaries. Therefore, Bian Xiao describes the operation method of setting graphic boundaries in AutoCAD20 10. Friends in need can study with Bian Xiao.

Double-click the shortcut coordinates of AutoCAD20 10, as shown in the figure below. The figures in this painting were casually drawn by Bian Xiao.

Enter command restrictions, which are case-insensitive. This command means resetting the model space boundary. As shown in the figure, press Enter again.

Set drawing boundaries. If you want to set A4 paper size, continue to enter 0,0; 2 10,297。 As shown in the figure. Of course, the paper size of A3 is 297mmχ420mm, so you should enter 0,0 in the command box; 297,420。

Of course, it can also be set according to personal needs. For example, after entering the command limit, enter the graphic boundary you want to set. Here will introduce a situation, as shown in the figure below. What should I do if I want the red rectangle as the graphic boundary?

At this point, you need to capture the coordinates of the lower left corner and the upper right corner of the rectangle. Select the rectangle directly, as shown. Select the right angle in the lower left corner first, and then look at the coordinates of the command box in the lower left corner. Similarly, capture the coordinates of the endpoint in the upper right corner, and then follow the above operation, first enter limits, then enter these two points respectively, and press enter, so that the graphic boundary is set.

AutoCAD|