How to adjust the inclination angle of sewer pipe

Adjustment method of inclination angle of sewer pipe;

The drainage pipe has a 45-degree elbow, and there is a cleaning port above the vertical pipe section, which mainly undertakes the tasks of rainwater, sewage, farmland irrigation and drainage. Drainage pipes are divided into plastic drainage pipes, concrete pipes (CP) and reinforced concrete pipes (RCP). Drainage pipe is a new type of plastic corrugated pipe, which is made of high density polyethylene and other additives.

Permeable corrugated pipe is made by punching holes in the groove and wrapping needle-punched geotextile around the pipe. The inclined pipe section shall be covered separately. After being covered by bricks, the top will be covered by normal columns, and there will be multiple pedestals below, which will occupy a certain area. However, it is also possible to place articles on a plurality of small base platforms.

Matters needing attention in installation of sewage pipeline

1, toilet water pipes basically pass through the roof, because this can reduce the probability of man-made damage, and the interface and outlet of hot and cold pipes must be parallel, usually the hot pipe is on the left and the cold pipe is on the right. When designing, the whole pipeline should avoid bending as much as possible and should be transported as far away from the circuit as possible. The position and slope of the pipe clamp should also meet the requirements, and the valves should be installed smoothly to facilitate future use and maintenance.

2. When installing hot water pipes, pay attention to the difference between the water inlet and the water outlet of the water heater. The water inlet is connected to the main valve, and the water outlet is connected to the toilet through a pipeline. After installation, first open the valve to determine whether there is water leakage, and then install the faucet and shower in the bathroom.

The bathroom is the darkest place in the whole family, and it is easy to accumulate moisture, so ventilation is especially critical. It would be best if the bathroom could be designed with a window. Without this condition, in order to prevent mildew and tide insects from appearing in the bathroom, in addition to installing an exhaust fan, the phenomenon of "package" should be avoided.