Simple shower room installation 10 installation steps that can not be ignored

In first-tier cities, house prices have remained high. If you want to buy a house, small and medium-sized houses will become the choice of most people. This type of house is very suitable for installing a simple shower room. So how to make the shower room with simple installation intact, we should keep in mind the following steps and precautions.

First, simple shower room installation steps

1. Stone base

Firstly, put the stone foundation in the position where it needs to be installed, then check the levelness of the stone foundation with a level meter, and finally determine the levelness of the stone foundation by adding gaskets or grinding, so as to ensure the stable installation and use of the shower room. It is also safe and reliable.

2. Guide rails and vertical materials

Fix the upper and lower guide rails and two vertical members of the shower room with screws. It must be fixed to ensure the smooth installation of the subsequent glass door.

3. Left wall material and right wall material

The main purpose of installing the left and right wall materials is to connect the shower room with the wall.

4. Screw fixation

Fix the left and right wall materials on the wall with 4X35 round head tapping screws to keep the wall materials vertical, so that the shower room will not tilt after installation.

5. Square frame

Lift the whole shower room frame (aluminum frame) so that the two vertical materials are aligned with the corresponding wall materials and sandwiched between them.

6. Correcting glass

Install the glass fixed on the left and right sides. First, put the U disk on the fixed glass and put it in the vertical material. Then use 4X 10 screws and clips to fix the fixed glass on the upper and lower guide rails.

7. Install waterproof glue

Installed on the left and right sides of the glass.

Both rounds are 8. device

The glass door of the shower room is installed on two wheels up and down, the installed glass door is hung on the upper guide rail, and then the two wheels are pressed to make the lower pulley enter the groove; You can adjust the glass grade and back cover with a Phillips screwdriver.

punching

First, drill a hole in the proper position of the vertical material with a drill with a diameter of 3.2.

10. Fixed; unchangeable

Then the wall materials and vertical materials are fixed together with decorative covers and screws, and then the installation layer is fixed on the frame clip, which is mainly to fix the shower room and ensure the safety of the subsequent shower room.

Second, simple shower room installation matters needing attention

1. About dimensions

When installing a shower room, first consider the size of the bathroom and try to choose the shower room that is most suitable for the layout of the bathroom.

Reserved position

Faucets, sprinklers, showers, circuits, etc. It must be maintained at the initial stage, and a water-retaining strip can be buried in front of the tile, so that it will not leak after a long time, but the disadvantage is that it is difficult to maintain and replace, and care and attention are needed during use.

design

The choice of stone basin and stone foundation at the bottom is also very important, which is mainly used for bathroom window sill, toilet seat, bathtub, wall column, distance washbasin, bathroom, door opening and so on.