Installation method of drainage traction rope for washing machine

Installation method of drainage traction rope for washing machine

The drain pipe of washing machine is usually connected to a pipe. It is best to install a hook near the pipe to ensure that the drain pipe can be higher than the ground and prevent water from flowing backwards. In this case, installing the drainage traction rope can better control the position of the drainage pipe and ensure that it will not bend or fold when using the washing machine. The following is the installation method of drainage traction rope for washing machine.

step

1. Find a convenient position near the drain pipe connector and insert the hook. This can usually be done on one side of the wall or on the bathroom floor.

2. Cut a length of 30cm from one end of the traction rope and tie it on the hook. When binding, make sure that the rope is strong enough to prevent loosening or moving.

3. Bypass the other end of the rope around the drain pipe and bind the rope again at the other end of the pipe or wall. Ensure that the rope and the drain pipe have proper elasticity to maintain the stability of the drain pipe.

4. Check whether the rope is firm and adjust it if necessary. Adjustment can be made by tightening or loosening the rope to ensure that the drain pipe is balanced and at the right angle.

5. Connect the drain pipe to the washing machine according to the installation instructions of the washing machine. Ensure that the drain pipe is connected correctly and installed firmly.

6. Start the washing machine and test it to ensure that the drain pipe works normally. If there are any problems, you can adjust the drainage pipe and the traction rope to solve any possible problems.

Generally speaking, it is very simple and easy to install the drainage traction rope of washing machine. It only takes some time to ensure the firm and correct installation, which can greatly improve the stability and reliability of the drainage system.