33 kongming unlock

The schematic diagram of 1 and 33 kongming lock components is as follows:

2. First, take out the longest components and arrange them according to the above figure;

3. Take another longest component and cross it with the previous one;

4. Combine the last long member and the cross structure into a vertical three-dimensional structure as shown in the figure below;

5. When the three-dimensional structure of the center is completed, take one piece according to the length specifications of the remaining part and prepare to put it into the three-dimensional structure.

6. Assemble the prepared three parts with different lengths from short to long from the bottom of the three-dimensional structure.

7. As shown in the figure below, take out various components for assembly.

8. Assemble the prepared parts from the left and right sides of the cross in the three-dimensional structure.

9. At this point, starting from the center of the three-dimensional structure, the lower part has been assembled, and then three parts with different lengths are prepared, as shown in the figure below.

10. Assemble the prepared three components as shown in the following figure, and assemble them from the bottom to the top of the cross in the order of first long and then short, so as to achieve the effect shown in the above figure.

1 1. This is more important. The whole pineapple lock should be rotated at a certain angle, and the effect after rotation is shown in the following figure. Please handle it carefully and don't fall apart.

12. After successful rotation, move the components on the right side of the highest column to the right in turn until one column is empty, as shown in the following figure.

13. After reserving space, prepare the parts corresponding to the following figure for final assembly.

14, the assembly effect is as follows:

15. As shown in the above figure, insert the prepared parts into the corresponding positions one by one.

16. At this point, all parts have been successfully assembled in the central structure, and then fine-tuning is needed for assembly.

17. Move the columns on the right side of the central column to the left for recovery, and assemble them into 33 kongming locks.