What is the production process of the whole cabinet countertop produced by the manufacturer?

1. Spare tools. Table saw (marble machine can also be used instead), marble machine, engraving machine, cross mill, plain film, louver, stone mill, polishing machine, wool wheel, polishing wax, several G clamps, several A clamps, tape measure, square ruler, pencil, railing, wooden frame of operation desk when making table top, artificial stone glue disposable paper cup, 80 # .3000.

2. Choose materials. According to the requirements of the drawings, select the corresponding model of table-top blank board with appropriate size, and try to select the appropriate leftover materials to reduce waste. If leftover materials are used, be sure to pay attention to the batch number to avoid color difference.

3. Pay off (mark). Draw lines on the artificial stone wool board according to the size and angle of the drawing to facilitate the next cutting (blanking).

4. Blank. Use table saw or marble machine with "toothless saw blade" on artificial stone wool board. Artificial stone made of ordinary materials is soft, so don't pay special attention. If the saw blade is hard, pay attention to cooling. In addition, we should also pay attention to the requirements of details such as "front edge" and "rear water retaining" in the drawings, and lay tops of corresponding sizes as required.

5. combine. Generally, the leading edge and the arc of the rear water retaining should be bonded first. Commonly used G-clamp, A-clamp combined with powerful pliers and wooden handrails, etc.

Be careful to clamp, especially the crystal table, be careful when bonding and pay attention to the cleanliness of the bonding place, otherwise it is easy to have "black marks" or "bright lines"

6. Wash the arc. Wash the board and G-clip with engraving machine to stop water, or wash the front edge straighter.

7. Stick on the upper part of the rear water retaining. If there is a front retaining water, it will stick together, which is also the main cleaning and clamping force.

8. Arc washing. The radians of the rear retaining water and the front retaining water.

9. The preliminary polishing adopts polishing, angle grinding and stone grinding. According to the degree of polishing, use different sandpaper on the polishing machine for water milling, and finally use 1000 mesh sandpaper for water milling.

10. Waxing: evenly coat a layer of wax on the polished stone surface, and then polish it with a wool wheel and a polishing machine.

1 1. stands for packaging.

12. Note, if allowed, it is not recommended to put the field-installed connector in the corner. It is best to make corners in the factory. If this is the case, you need to consider the arc at the front corner when making the corner in the factory, and it is not good to make it directly into a right angle.