How much does it cost to put in a set of water coolers

Approximately 400 dollars! The so-called 'water cooling' actually requires a fan to dissipate the heat. (This is the active water cooling, if the passive type does not need a fan) The following content is the active water cooling of the construction of the explanation. However, is it better to use water cooling than air cooling? Water' in water cooling is the heat transfer from the heat generating point to the heat dissipating point (similar to a split air conditioner). Most of the water cooling points in computers are a combination of a heat sink and a fan. But this combination can be big or small. Heatsink: small one can be an 8cm fan. For a large one, it can be up to 9 x 12cm fans. Since the air-cooling of computers nowadays can be as large as 12cm fans, if only one 8cm fan is used for water-cooling, the performance of water-cooling will not be better than that of a 12cm air-cooler. If the active water cooling fan breaks down, the water temperature will boil to 70-80 degrees, water cooling is quiet enough The biggest reason for using water cooling is to effectively control the noise caused by the rotation of the cooling fan. When you open the chassis, you can see that apart from the water-cooled cooling tubes, there is also a large cooling fan on top of the chassis. Since the chassis relies on water-cooling, the noise emitted from the fan during operation is very low. In addition, since this series of products is mainly sold as Quiet & Noise Reduction, there is also a special arrangement in the selection of hard disks, that is, adopting models with lower noise levels, so that overclocking, cooling and working can all be carried out in a quieter environment.