Installation mode and wiring principle of led fluorescent lamp

How to connect and install led fluorescent lamp-wiring diagram and wiring method

Advantages of LED fluorescent lamp products:

LED fluorescent lamp light source adopts high brightness LED, including cold white, warm white and positive white. Compared with traditional fluorescent lamps, LED fluorescent lamps have the following advantages:

1, energy saving: 80% less than traditional fluorescent lamps; ?

2, environmental protection: no ultraviolet rays, infrared rays and other radiation, no harmful substances such as mercury, and no pollution caused by lamp body recycling;

3, long service life: normal use can reach more than 50,000 hours;

4, no stroboscopic: LED works at constant current, effectively reducing LED light decay, starting quickly, no flicker, and protecting eyes;

5. Installation is simple. During installation, the original fluorescent lamp is removed and replaced with LED fluorescent lamp, and the ballast and starter are removed, so that 220V AC mains power is directly applied to both ends of the LED fluorescent lamp.

1. Traditional fluorescent tubes have two connection modes: electronic ballast and inductive ballast. The wiring diagram is as follows:

?

2. Connection mode of 2.LED fluorescent tube: Remove ballast and/or up converter, and connect live wire and zero wire at both ends of the bracket, as shown in the following figure:

?

Installation instructions:

1. Remove the up-converter and rectifier, and connect the live wire and zero wire of the commercial power to the left and right ends of the bracket respectively.

2. The 2.LED tube has a built-in power supply, and the two pins of the G 13 interface are in a short circuit state, and the interfaces at both ends are consistent.

?