How to install floor slats

The floor batten is actually a buckle with various materials and models. Different places use different models. It mainly includes the contraction joint of the floor and the connection between the floor and other materials. There are three main types: metal, Morse and solid wood, but Morse uses the least. The metal strip is drilled with a 6-point drill, expanded with 6-point plastic, and then tightened with special screws. If you can't determine the location of the wires and water pipes, you can paste them directly with glass glue. Or both, double insurance. As for solid wood, the following steps are generally taken: drilling: 1. Before drilling, observe the direction of water and electricity connection to prevent mistakes. The interval between drilling holes should not be too large, otherwise the skirting line will be difficult to stick to the wall. Drill holes in the wall with special tools. The baseboard is generally 2m in length. In order to make the skirting board fixed more firmly, the spacing of drilling holes should be about 40cm, and the spacing at the interface should be smaller. Nail the small piece of wood into the hole just punched. 2. The nail for fixing the baseboard is nailed to this batten and directly nailed to the wall, so the nail is easy to loosen. Note: Because the pipeline of hydropower project is buried in the wall, the position of the pipeline is directly below the switch socket, so the position should be calculated when drilling to avoid damage.