Traditional Culture Encyclopedia - Traditional virtues - How to wrap the vertical bar in the hairdresser?

How to wrap the vertical bar in the hairdresser?

Six international standards for arranging steel bars;

1, traditional arrangement: more suitable for regular short hair perm.

According to the needs of fashion hairstyle, it can be divided into five or six areas. The fifth zone is suitable for fashionable hairstyles that comb backwards, and the sixth zone is suitable for shorter fashionable hairstyles.

2, bricklaying arrangement: more suitable for people with less hair.

3. Fan arrangement: a fashionable hairstyle suitable for back combing.

4, vertical: suitable for long hair spiral fashion hairstyle.

5, zigzag arrangement: suitable for big wave fashion hairstyle.

6, circular arrangement: suitable for short hair wave fashion hairstyle.

Vertical bar

1, partition

Draw an 8-point-wide horizontal line upward from the neck point; Then from the horizontal line upward, draw a U-shaped line with a width of 8 minutes (this area is characterized by a narrow top and a wide bottom); Draw a horizontal center line from the gold point of the U-shaped line with a width of 8 minutes, which is divided into three areas; The other part in front is area 4.

2. On the bar

First, put the bar from the middle of the neck, one bar on each side of the midline (it is advisable to have less hair pieces, so that the seam between the two bars is smaller; Then arrange them on both sides. The angle of the tab is 90 degrees, and there is about 10 on the * *. Note that the upper part of the barbell should not be higher than the horizontal line to avoid squeezing the bar with the upper area.

Zone 2 is also 90 degrees, and the hair piece is mainly trapezoidal, which is the seam between the ribs at the wide end. There are about 20 bars in this area;

Area 3 is divided into two halves according to the center line, each half is semicircular, and it is divided into two parts and one part from the sharp corner in the middle, and then each hair piece is cut into an angle, and a crossbar is placed on the top hair piece to lean against it; Put a bar on the hair piece cut below and lean down; This area can have a total of 8 bars, or each semicircle can be divided into 3 pieces and subdivided into 6 pieces, 6 bars, 12 bars.

Area 4 is the front area, which is arranged in a standard strip-shaped way, with two rows, and there are about *** 10 strips. 90 degree pull ring.