Old-fashioned toilet water level adjustment method

There is a screw in the water tank and an iron. The iron piece in the middle is pulled up and down, and the down is high. Open the toilet lid and you can see the ball linkage mechanism inside. There is a screw on it. You can see that there is a screw that can be adjusted upwards. You can meet your requirements. Low water level can save water. The simplest way to save water is to put one or two beer bottles filled with water in the water tank, and one bottle can account for about 700 ml.

Since the landlord doesn't understand the water part, he will use the most popular words:

In the picture, the white part of the white cylinder has two blue gears, and the water level of each gear is adjusted. Adjust up and down to see the change of actual flushing volume. Pay attention to the flushing quantity, not the water quantity in the water tank. Looking at a full tank of water, you can wash it clean, and you don't have to put it all away.

If it cannot be adjusted due to scale or other reasons, the simplest way is to put an appropriate amount of empty water bottles and tie them in a fixed place to reduce the water level of the water tank.

The water in the water tank is not the final water for each flushing.

How to adjust the water parts of the toilet?

1. Installation and adjustment of water inlet valve?

1. Installation of water inlet valve? Take out the parts of the water inlet valve as shown in the figure. Then install the adjusted inlet valve on the inlet hole of the water tank, put on the gasket and tighten the fastening nut. (Note: The installation direction of the water inlet valve should ensure that the water supply pipe cannot be folded or interfere with the work of other components. )

Schematic diagram of toilet water level adjustment 1

2. Water quantity adjustment of water inlet valve water tank? As shown in the figure, first turn the clamp of the water inlet valve to the "open" direction. Then pull the water inlet valve body to raise or lower the water inlet valve as a whole. For the locking and releasing of the card, please refer to the identification of the water inlet pipe.

3. Fine-tune the water level of the water inlet valve water tank

Adjust the adjusting lever as shown in the figure to raise or lower the water level of the water tank. Turn the adjusting lever counterclockwise, the floating box will drop, and the water level of the water tank will drop. On the contrary, rotating the adjusting lever clockwise will make the floating box rise and the water level of the water tank rise.

Fig. 2 toilet water level adjustment

Second, the installation and adjustment of drain valve?

1. Installation and removal of drain head.

A. Turn the valve body counterclockwise according to the arrow direction in the figure below, and then take out the valve body upward.

Fig. 3 toilet water level adjustment

B loosen the fastening nut and take out the washer. Then install the drain head on the drain hole of the water tank and adjust the appropriate position. Install the washer and tighten the fastening nut.

C, as shown in the figure, fix the locating buckle of the valve body on the locating hole of the drainage head. Then rotate the valve body clockwise. It's installed, and it's OK when you hear a click.

Fig. 4 toilet water level adjustment

2. Adjustment of drain valve (small displacement adjustment)? As shown in the figure, the up-and-down movement of the cleaning cup can adjust the water displacement in a small range. The higher the position of the adjusting cup, the higher the water saving degree and the smaller the water displacement. On the contrary, the lower the position of the adjusting cup, the greater the displacement.