What is the construction technology of marble floor?

Calculate how much it will cost to decorate your home.

1. Before construction, the ash, oil stain and sundries on the ground should be washed with clear water and dried.

2, before the shop is stuck, need to use theodolite pay-off on the ground, and pop up two perpendicular lines.

3. Determine the ground elevation and make control points on the ground, so as to better control the ground height during construction.

4. Apply a layer of interface agent to the ground, and then apply the prepared dry mortar. Note that the ratio of cement to medium sand is about 1: 4, and it is better to hold it in your hand and disperse it on the ground.

5. See if there is glue on the back. If there is no glue, it is necessary to brush bonding mortar or plain cement slurry on the back to avoid problems such as flashing alkali after the product is laid.

6, put the ceramic tile on the dry mortar, and then use a leather hammer to knock it flat. After the ground strength reaches the standard, joint filling material shall be used for joint filling.

7. After joint filling is completed, grind the ground. If the surface roughness is poor, grind it with 300# diamond resin hard grinding block and add water. For those with high requirements on construction technology, 1000# diamond resin soft water grinding plate can be used for fine grinding or 3000# diamond resin soft water grinding plate +A2 can be used to improve the sealing degree of ceramic tiles.

8. Finally, use the crystal face machine, animal hair pad, 3M pad and marble mirror grinding cream No.2 for polishing.

Enter the area and get the decoration quotation for free.

Enter the area and get the decoration quotation for free.