Herringbone weaving of wool slippers

The weaving method of herringbone pattern of wool slippers is as follows:

1. First, wind the wool into a circle and start knitting from the circle (equivalent to making a loose knot), as shown in the figure below.

2. Next, start from the first lap with 4 stitches, add 4 stitches, ***8 stitches, and weave 2 more stitches, as shown below.

3. Then, add needles from 1 to 2 and from 8 to 16, as shown in the following figure.

4. Then continue to add stitches after knitting for 3 times, or change 1 stitch to 2 stitches and increase from 16 stitch to 32 stitches, as shown in the following figure.

5. Then continue knitting for 3 times, adding 8 stitches on each side (8 stitches are soles), and adding 2 stitches every 3 times until the appropriate number of stitches is increased, as shown in the following figure.

6. Next, after adding the appropriate number of stitches, continue to knit to the appropriate length, as shown in the figure below.

7. Then, always close the heel. This length can be directly placed on the sole for comparison, as shown in the following figure.

8. Then, return from the heel and knit upward. When knitting, pick up the needles on both sides and add needles. The total number of needles can be 2-4 less than the outside, up to the toes, as shown below.

9. Then close the inside of the back plug, because it is usually woven with two strands, as shown below.

10. Finally, follow the same steps to operate the other one and see the effect, as shown in the figure below.

Precautions:

In the process of compiling, we must pay attention to safety because we need to use sharp objects such as wool labels; In addition, if you are not satisfied with the color of the wool in the picture, you can change it to another suitable color according to your personal situation. The knitting method is exactly the same as the above operation steps.