How to add an antenna to the intelligently driven low-voltage lamp

The low-voltage lamp with intelligent drive is generally a constant voltage scheme plus antenna.

1. The light strip is installed in series with the double bright sensor, and the positive and negative poles are distinguished. The red line at the output end of the dual light sensor is connected with the anode of the light bar, and the black line is connected with the cathode of the light bar.

2. Connect the input end of the dual-bright controller with the output end of the lamp power supply, and divide the positive and negative poles equally. The red wire is connected to the positive electrode, and the black wire is connected to the negative electrode (the positive electrode, negative electrode and ground wire will be marked at the power output end of the lamp belt, and the ground wire may not be connected).

3. Turn on the 220V power supply, and the light strip will light up. At this point, the light strip will be fully lit. Do not move within the sensing range of the dual light controller during the test, otherwise it will be triggered to be fully lit. When no moving object is detected, the light will automatically switch to dim state for about 15 seconds. At this time, when people approach again, they will automatically switch to the full bright state, so they are installed.