Necklace knotting method

7 1 jade wire is used in the same way.

1. Prepare four lines of 150cm and tie a temporary knot at 20cm.

2. Weave four strands with long-end thread, which can be 60-80cm, depending on the head circumference.

3. Thread one end of the four strands into the hole of the pendant, then align the two ends of the four strands, take a 50cm 7 1 thread with these two groups of threads as the axis, and tie diagonal knots on it respectively. Note: the front of the pendant is consistent with the front of this oblique knot.

4. The two windings are respectively folded back to form an oblique knot.

5. The two winding wires cross each other to form an oblique knot on the shaft.

6. Pull the winding down to make a shaft, and three of the four shafts will make a diagonal knot, which is the same on the left and right.

7. Two threads without oblique knots are threaded together into 1 3mm gold beads, and then they are obliquely knotted on the left and right shafts respectively. Tie a diagonal knot on the last two shafts.

8. Pull the top one down to make a shaft, and the rest of the thread is made into a diagonal knot. The left and right are the same. The last two shafts will be made into oblique knots, and the extra threads will be cut and burned. You can also wear a 2mm gold ball on each line as in the video tutorial, and then cut it off and burn it.

9. Take 1 root as a circle and 1 root as a flat knot on the circle.

10, after about nine flat knots, cut two windings and burn them.

1 1. Pull the flat knot loop onto the four-strand braid.

12, the flat knot loop is minimized, so it can be pushed on four strands, and the extra two threads are cut off and burned.