How to use the grease gun?

The application steps of grease gun are introduced:

1. Unscrew the oil gun head and separate it from the barrel.

2. Lock the locking piece at the end of the barrel and push the handle at the end of the barrel.

3. Dip the beginning of the grease gun into the grease barrel, about 30mm deep, pull the handle at the barrel end, and suck the butter into the barrel.

4. Screw on the yellow spear head again, press and hold the tail of the barrel to lock it, and push the driven handle to start exhausting.

5. Control the vent with your fingertips, and see that there is grease discharged from the vent to complete the exhaust.

6. After filling, confirm the grease filling position of the equipment, complete the connection of the nozzle, and shake the handle with arm strength to add yellow grease.

Extended data:

Matters needing attention in operation of grease gun:

1. When the grease gun is tested or working, it is forbidden to point the grease gun at anyone or anything to avoid injury.

2. It is recommended to use butter with good quality and no impurities to avoid blocking failure caused by inferior butter.

3. When using the grease gun, handle it gently to prevent the rubber bowl in the barrel from working normally due to the deformation of the barrel under the action of external force.

4. When the air is exhausted and the butter is still not produced, stop the operation and carefully check the blockage in the spray gun. After troubleshooting, the grease gun can be operated again.