How to tile the bathroom and matters needing attention

As we all know, the laying of bathroom tiles is an important project, and only by following the correct steps can there be no leakage. So, how to tile the bathroom? And what precautions are there when paving? Let's take a look at it next!

How to tile the bathroom? 1, how to paste tiles in the bathroom, first choose materials, and it is best to put the tiles in the bathroom with small square bricks.

2. Then mix the cement and building glue, and fully stir them into paste.

3. How to tile the bathroom? Scrape the glue on the back of the tile with a scraper, and then flatten it with a blade. This can be done from top to bottom or from left to right.

4. After the bathroom tiles are finished, sew them with white cement slurry to fill the gaps between the tiles.

Precautions for ceramic tile laying in bathroom: 1. Must be on the construction site to prevent workers from wasting tiles. In addition, imperfect tiles should be placed on the back of cabinets, sinks and mirrors, which will not affect the appearance and save money.

2. Before masonry, roughen the wall, which will increase the tensile area between the cement and the wall.

3. When making a mosaic, you must ask Mei Sen to pull the cable to make it flush with the horizontal plane. No matter how good the process is, the best thing is that you should let it use tools to control the quality.

4. It is best to use cement slurry on the surface of the load-bearing wall, but the fireplaces in the kitchen and toilet roads must be added with glue 108 to improve the cohesiveness of cement mortar.

5. After tiling for 3 hours, wait for two or three hours, and then touch the four corners of the brick to see if there is an empty drum. If you listen to the empty drum, you have to post it again to avoid more trouble in the future.

6, the toilet floor must have a slope to leak, to facilitate water flow. In addition, the bathroom pipe decoration should try to avoid changing the position of drainage pipes, sewers and floor drains, and avoid damaging the waterproof layer and causing leakage.

7. When mixing colors with additives for brick joints, it's best to debug with toner first, and then determine the dosage, otherwise it will be too shallow or too deep.

The above is how to tile the bathroom and the matters needing attention when laying it, hoping to help some people in need!

Tubatu Online provides you with "every decoration quotation, 1-4 local decoration companies, 3 sets of decoration design schemes" and the decoration pit avoidance strategy for free! Click this link:/Zhu Ye /zxbj-cszy.php? to8to _ from = SEO _ zhidao _ m _ jiare & amp； Wb, you can get it for free ~