The introduction of lead hook binding method only needs a few simple steps.

1. Pierce the hook tip from the head of the soft worm along the axial direction of the worm. It is necessary to ensure that the hook tip always follows the axis of the insect body after entering the insect body and cannot deviate.

2. After the hook tip pierces the worm, it moves along the axis. At the same time, the body of the soft worm is nested according to the shape of the hook, so that the hook can continue to move forward and reach the previously measured puncture position.

3. When the hook tip reaches the piercing position, bend the worm body to make the hook tip pierce.

4. When the hook tip is completely pierced from the worm, the installation is not completed. There is a lead-cast barb on the neck of the lead hook, so that the installed soft worms can be firmly combined with the hook body, and will not be bitten off by fish or hung away by underwater debris.

5. Hold the worm's head with your fingers and push it forward. Until the neck and barbs of the lead hook are all buried in the insect body, the head of the insect body is closely attached to the head of the lead hook.

6. This is the final state of assembly. The position of the hook will not affect the swing of the tail of the soft bait, and it will also effectively pierce when there is a fish attack.