How to make simple flowers with ribbon

Make simple flowers with ribbon as follows:

1, first, we will cut the ribbon into a small strip of about 30 centimeters, this small strip is for tying the flowers with.

2, next, we will coil the ribbon into a circle, a circle after the disk.

3, and then disk 4 laps, so that the disk into 5 laps, and then cut with scissors, in the joints of the place with a transparent adhesive to fix the two broken ends can be.

4, and then the circle will be slightly folded, see the picture below.

5, and then fold the fold upwards a little, it becomes the picture shown below.

5. Next, we draw two diagonal lines on top of the ribbon at the bottom.

6, and then use scissors to subtract along the diagonal lines.

7, and then unfolded with a thin ribbon through the center, tied tightly.

8, then next, we use our hands to unfold the ribbon loops one by one.

9, each of the ribbon loop 360 ° rotation, and gradually will be 10 circles all right.

10, during which you can use a thin ribbon to fix the coil, and then slightly adjust the position of the petals.

11, so, a simple ribbon flower is done.

Ribbon basic introduction:

Ribbon is handmade a delicate tape, different colors of ribbon, represents a different meaning. Symbolizing the "safe return" of the yellow ribbon; symbolizing the "health and love" of the green ribbon; symbolizing the "beginning of love" of the red ribbon, different ribbons, fluttering in the same sky, conveying our same love and blessings. These different ribbons are fluttering in the same sky, conveying our same love and blessings.