How to carve a wooden plaque

Main materials: a cedar board; print a good font

Tools needed: a G clip; a carving knife; paint in the right amount

Production steps:

1, think of the font you want to carve, planning, go to the building materials market to pick the right cedar board edges (cheap), print the contents of their own wants (choose a good font), if the font is smaller, the font can be increased by using the quick key ctrl+ to increase the font. If the font is small, you can use the shortcut key ctrl + increase the font. Printed fonts cut, with a glue stick or transparent tape on the board

2, patiently and carefully with a carving knife in the font want to remove the part of the dug out

3, all dug out, the font inside is still very rough, sandpaper sanding, the fine detail of a good repair, plaque other stains on the place of the sanding clean, rounded corners sanding.

4, you can choose to paint, the font and the surrounding brush into the color you want. Optionally, you can use resin + color essence poured into the grooves of the font.

5, continue pouring

6, wait until overnight, wait for the resin to solidify, the color can be adjusted to your favorite color through the color essence, in order to enhance the contrast, you can choose the brown (before solidification)

(after solidification)

7, and then a little bit of sanding, finishing, on the wood wax oil, the final product

Reference Sources:< /strong>People's Daily News - The Birth of the "Good" Plaque