Zotye t600 gear car doesn't go, the throttle doesn't go, and the left wheel sounds abnormal.

The throttle only leaves when the landing gear is stationary because:

1. It may be that the engine throttle is too small and the fuel injection quantity of the injector is not enough.

2. It may be related to the control system of the gearbox itself and the signal problem of the actuator. The shift valve is not sensitive, which leads to the shift is not in place and the oil circuit cannot be opened.

Most automatic cars (especially those produced before and without AUTOHOLD function), after the engine starts, step on the brake and put on the D forward gear. After releasing the brakes, they will move slowly under the action of idle speed (like manual gear 1 gear), but the speed is relatively slow, and the car will only accelerate if it continues to step on the accelerator.

However, there are exceptions to everything. For structural reasons, some gearboxes are designed not to move until the gears are engaged. For example, Audi's Multitronic CVT uses a multi-plate clutch. After you put on D gear, the clutch is still disengaged. You must step on the accelerator and gradually step on the clutch before the car can move forward.

In fact, in the final analysis, it is not a fault, nor is it a fault. You can first check whether your gearbox is designed like this, whether the brake disc is rusted, whether the car has the autohold function, and whether the automatic transmission model without the autohold function has the hand brake. If the above reasons are ruled out one by one, then don't say much, just drive the car directly to a 4S shop or a reliable repair shop and honestly carry out detailed maintenance. After all, we must attach great importance to the gearbox. In case it breaks down halfway, it's no joke, and there are great security risks.