How to clean the throttle of Li Xia N5?

For the cleaning method of electronic throttle vehicles, it is suggested that two people cooperate, and some models need diagnostic computers to cooperate with the throttle.

1. Remove the air inlet hose (there is a sensor plug on the air inlet hose, try not to pull it out, just put it aside).

2. Turn on the key, and all the instrument lights will light up that gear (do not start the vehicle).

Step on the gas pedal to see if the gas pedal is fully open. Some models only move a little.

4. If the throttle moves a little, first turn off the power button and pull it out, wait for about half a minute (otherwise the fault code will easily appear), push the throttle baffle with your hand, hold it aside with a screwdriver, clean it and switch sides.

5. Spray detergent and start brushing with a toothbrush, focusing on the side joint of the throttle baffle. Spray a proper amount of detergent to clean, and at the same time cooperate with a toothbrush until you are satisfied.

6. After confirmation, reinstall the air inlet hose and start the vehicle. Don't step on the accelerator when starting, the starting time will be a little longer, and the engine will shake a little in the early stage. Idle for a few minutes, and suck the cleaner flowing in the intake manifold into the engine for combustion. Don't slam on the accelerator at this time.

The cleaning method of cable throttle valve is the same as above, but it needs to clean the idle motor once more. The two screws are generally cruciform or spline screws (counted as special tools), and the idle motor plug is generally four wires. Focus on cleaning the head of idle motor and the position above the corresponding throttle.