1 1 Bora how to change the coolant?

Pacific auto network 1. First of all, let the engine be in a cold state, otherwise it is easy to splash out when adding coolant. Then you can open the hood and find the engine coolant storage tank. 3. Screw the water tank cover counterclockwise, open the water tank drain valve (let out the coolant), and of course clean the inside. 4. Then directly replenish the coolant of the same specification into the water tank until the liquid level reaches the maximum scale line (MAX).

Then it should be noted that in the process of filling engine coolant, be careful not to spill it. If it comes into contact with the exhaust pipe, it is likely to produce an unpleasant smell, and even smoke and catch fire. So when you touch the exhaust pipe, you must wipe it off with a wet cloth as soon as possible. I believe you don't want to see the car suddenly catch fire.

However, if it is found that the coolant has been almost consumed in a short time, it is probably caused by leakage, which may be caused by the damage of radiator cylinder pad or the looseness of overflow box, water pump joint surface and cooling system pipeline, so it is necessary to go to the nearest garage for maintenance in time. You know, if there is a lack of coolant, it is likely that there will be a "boiling pot" phenomenon.

Method of adding coolant:

1. Park the car on a flat and solid ground until the engine is completely cooled.

2. Open the engine compartment cover. On the left is a purple oval water tank. When the engine is cold, check the coolant level through the side mark of the expansion tank.

3. If the coolant level in the expansion tank is lower than the minimum mark ("min"), coolant must be added. When the engine is hot, the coolant level may be slightly higher than the upper limit of the marked area.

4. When filling the coolant, wrap the coolant expansion tank cover with a suitable cloth to prevent hands and arms from being burned by high-temperature coolant or steam.

5. Carefully unscrew the cover of the coolant tank and inject new coolant that meets the requirements of our company. After filling the coolant, the liquid level must be between the two marks of the expansion tank. Tighten the lid.