Matters needing attention in cleaning automobile throttle

The throttle can be cleaned without disassembly, but the sealed part of the air inlet must be cleaned; The selection of cleaning agents is particularly important, and cleaning agents with strong corrosiveness must not be used.

When cleaning, pay attention to the cleaning strength to avoid damaging the coating. When cleaning the throttle, it is necessary to disassemble the engine of the vehicle, so it must be done when the engine is completely cooled, otherwise it will cause serious consequences, such as burns.

Dirty throttle is mostly caused by poor air quality and poor oil quality. The carbon deposit produced in the process of gasoline combustion will infect the throttle valve due to negative pressure, which will make it not close well, thus increasing the intake air, causing signal transmission errors, leading to high fuel consumption and engine idling jitter. Therefore, during the maintenance period, always check the throttle opening. If it exceeds the normal range, it should be cleaned.

When cleaning the throttle, first remove the intake pipe to expose the throttle, remove the negative electrode of the battery, turn off the ignition switch, straighten the throttle plate, spray a small amount of carburetor cleaner into the throttle, and then carefully scrub it with polyester rag or high-count non-woven fabric. Deep in the throttle, where you can't reach it, you can clean it carefully with a rag. After cleaning, install it in reverse according to the procedure just removed. After installation, start the initialization of the throttle. Million car purchase subsidy