How to remove the intake pipe on the mg6 throttle?

How to wash the mg5 throttle? Cleaning method of MG mg5 throttle:

1. After the hood is removed, we can usually see the throttle. There are some empty gas pipes around the throttle valve. We need to dismantle these pipelines and make clear the location of each pipeline.

2. After removing the gas pipe on the throttle, we can remove the whole throttle. Trent's throttle is fixed on the engine block with four bolts, and we can quickly remove it with suitable tools.

3. The side of the throttle near the combustion chamber is generally dirty with black carbon deposition, which is the main part that needs cleaning.

4. Cleaning the throttle is mainly to remove the carbon deposit on it. We can use special throttling cleaning liquid or detergent. It should be noted here that the cleaning principle of this cleaning agent is to dissolve carbon deposits, and its composition is harmful to human body. It is best to wear gloves and masks when cleaning;

5. Spray the cleaner to the position with more carbon deposits on the throttle, and wait for about 5- 10 minutes to dissolve the carbon deposits. Using brushes can speed up the removal of carbon deposits. When we see that the stain on the accelerator has completely dissolved, we can wipe the detergent inside the accelerator with a clean towel. The picture above shows the clean back of the throttle, and there is no trace of carbon deposit at all.

6. Install the cleaned throttle valve on the machine body according to the original position, and then install all air pipes to complete the whole cleaning process of the throttle valve. After all the hardware is installed, we need to initialize the throttle valve. The following is the throttle initialization method of Trent HR 16DE engine: 1. Open the second key. At this point, all the indicators on the dashboard are lit. After waiting for 20 seconds, press the accelerator to the bottom and hold it for about 10 second. Release the accelerator pedal, turn off the ignition switch and pull out the key. 2。 Turn on the second key, hold it for 30 seconds, then turn off the ignition switch, pull out the key and initialize it.