Use of capacitor machine

1. Turn on the power switch of the capacitor forming machine, and the indicator light will be on. Adjust the governor knob to zero, and then turn on the feed switch. Set the governor knob on the vibrating plate of the electronic component molding machine to zero, and then turn on the toggle switch on the vibrating plate to adjust the speed to a suitable position.

2. Put the parts to be processed into the vibrating plate of the capacitor forming machine, then turn on the feeding switch and the vibrating plate switch, and adjust the vibration of the vibrating knob and the feeding knob at the same time, so that the parts can be transported on the vibrating plate and pass through the interface smoothly. Transport on the track.

3. Insert the air source and adjust the appropriate air pressure according to the size and weight of the assembly. Adjust the left and right distance of the track of the capacitor forming machine so that it does not affect the stroke of the component and does not need to be too wide. The width of the middle inner edge is greater than the width of the component 1-2mm. The vibrating plate interface should be smoothly engaged with the cutting machine track.

4. Adjust the height of the cutting foot to be slightly higher than the component material 1- 1. 5 mm .. Adjust the knob of the capacitor forming machine and compare the ruler pointer with the required foot length. Then turn on the foot switch of the capacitor forming machine and try to cut 1PCS to measure the size. When the foot length meets the requirements, it can be mass-produced