Where is the mazda 6 idle air control valve?

Where is the mazda 6 idle air control valve? Where is the mazda 6 idle air control valve? On the engine intake valve body, the front end is inserted into the valve body, and the rear end is made of black plastic and connected with the wiring harness. Caution: Don't confuse it with the throttle position sensor installed nearby. When the idle load of the engine increases, ECU controls the idle control valve to increase the air intake, thus improving the idle speed and preventing the engine from being unstable or flameout. Installation position of idle speed control valve: 1. The idle speed control valve is installed on the vent hole beside the throttle. According to the ignition signal, when the engine speed is lower than 750 rpm, even if the idle control valve acts to increase the engine speed, the idle control valve stops acting when the alarm speed exceeds 1050 rpm. 2. For vehicles equipped with air conditioning system, this control valve is also called idle acceleration valve. After the air-conditioning compressor runs, it will produce engine load, reduce the engine idle speed, and the idle speed control will act accordingly to maintain the stability of idle speed. 3. Air flow sensor, also known as air flowmeter, is one of the important sensors of EFI engine. It converts the intake air flow into a signal and sends it to the electronic control unit (ECU), which is one of the basic signals that determine fuel injection. This is a sensor for measuring the intake air flow of the engine. @20 19