Ea2 1 1 How to disassemble the intake manifold?

1. Remove the throttle control unit; Remove the engine hood; Pull off the vacuum hose (arrow) from the intake pipe to the brake booster.

2. Unscrew the bolt of the fuel distributor and press out the locking pin of the cable guide from the fuel distributor (as shown by the arrow).

3. Disconnect the electrical plug (arrow), remove the cable on the air inlet pipe and put it aside; Turn the activated carbon canister solenoid valve n. ...

4. Unplug the plug 1 and remove the throttle control unit J338 (arrow).

Installation shall be carried out in the reverse order, and the following points shall be noted during installation:

① Replace the sealing ring between the intake manifold and the cylinder head.

② Replace the sealing ring between the fuel injection valve and the intake manifold and slightly soak it in clean engine oil.

③ Insert the fuel distributor and fuel injection valve into the intake manifold and press them in evenly.

④ Pay attention to the correct installation of the sealing ring between the lower part and the upper part of the intake manifold.