Citroen sega accelerator cleaning

1. No disassembly and cleaning is required.

Disassembly-free cleaning is relatively simple, and there is no need to replace some sealing rings, gaskets and other parts. At present, cleaning without disassembly is adopted in most cases.

2. Remove all throttle bodies and clean them.

If the oil plug is particularly serious, it needs to be removed and cleaned. If the situation is serious, even the cylinder head should be uncovered for cleaning. Therefore, it is recommended that all car owners and friends go to a professional repair shop to clean the throttle.

How to clean the throttle yourself? Tools needed: carburetor cleaner, gloves, toolbox.

Remove the throttle.

Remove the engine hood, so as to remove the pressure pipe and the pipeline fixed to the pressure pipe. In the process of removing the screws, the owner should pay attention to prevent the screws from falling into the engine compartment. After removing the pressure pipe, we can see the throttle of Golf 6. Because the throttle valve is relatively low and there are many surrounding pipelines, the owner should be careful when disassembling the throttle valve to avoid damaging the pipelines. When the throttle is taken out, the engine block is exposed. The owner must hold this empty lock and remember to cover the exhaust pipe to prevent foreign objects from entering the engine block.

2. Clean the throttle

After taking out the throttle, we can find that there are a lot of oil stains inside and outside the throttle, and a lot of dirt and impurities are attached. After spraying detergent on the dirty parts, you can wipe them carefully with a cloth. Don't be lazy when wiping, pay special attention to those gaps that are easy to hide bad people and practices. If the gap is too small, you can clean it with a cotton swab and some detergent. As long as we wipe it carefully, the throttle will be as clean as new. With a clean throttle, the car can breathe smoothly and freely.

3. Install the throttle valve

The four screws that fix the throttle valve can be screwed by hand first, because the hand is sensitive, so avoid screwing the screws directly with the sleeve, and then tighten and fix them with tools after screwing them by hand. Then plug in the plug, which needs a little force to install. After hearing the sound of "beating", the explanation is fixed. After installing the valve, you can install the hose. There will be two small grooves on both sides of the hose, one large and one small, which can be aligned with the raised marks on both sides. Both ends of the hose should be fully inserted. If it is difficult to install, you can screw it at the same time. After the concave points at both ends are completely aligned, touch the bottom of the hose by hand to ensure that the bottom is completely inserted, then tighten the screws on the clamp and install the engine decorative cover, and the cleaning work is completely completed.