Does the Fox accelerator need a computer to be removed and cleaned?

1. No matter whether you wash the throttle manually or automatically, you don't need a computer, because it is only the process of troubleshooting fault codes. If you turn on the yellow light, it won't light up after matching, but it seems that even if it doesn't match the computer, clean the throttle after the yellow light is on, and the yellow light will go out automatically in two days.

2. To match the throttle opening, you can use the following operations: turn the key to the second gear, wait for 4-5 seconds, then turn to the second gear for 4-5 seconds, ignite, turn on the car headlights, and turn on the air conditioner (A/C) at the same time, wait for about 1 second, and hear the "click" sound of the engine box (the specific sound is unknown).

The above two points were said by the maintenance master after cleaning the throttle valve in 4s, and they are also the operation steps of the master after cleaning in 4s shop. But I haven't tested it myself, and I need your further verification. If there are any differences or problems, I hope you can put forward and improve them as a supplement to DIY throttle cleaning.

Manual matching steps after cleaning the Fox throttle: (When cleaning the electronic throttle, you can take off the key and clean the throttle with cloth and cleaning agent) 1.

Turn the key to NO and wait 15 seconds, turn off the key and wait for 20 seconds, turn on the key to NO and press the accelerator to the bottom and wait 15 seconds, turn off the key and wait for 20 seconds. be filled/suffused/brimming with

Turn off the key. Turn off the key instead of pulling it out.

2

An easier way is to unplug the F35 fuse and wait for 20 seconds. It is the safety of the engine control unit, so it is not necessary to pull out the other two.