Haval h6 throttle disassembly-free cleaning course

Haval h6 throttle disassembly-free cleaning course

1. Put a towel under the throttle to prevent the throttle cleaning fluid from flowing around. Spray the electronic throttle cleaner on the throttle surface, and wait for 3 minutes after spraying to fully decompose the carbon deposit;

2. Since the throttle is an electronic throttle, you need to get on the bus at this time, turn the key without starting it, just turn on the electricity. Ask a friend to help you step on the accelerator to the end. Then aim at the throttle valve and the end face of the shaft for spray cleaning, and wipe off the residual detergent liquid with a towel at the same time;

3. Start the engine at this time. At this time, it may not be easy to start. You can put a throttle on the ignition. Then increase the engine speed to 1200~2000r/min, and clean the throttle chamber (pay attention to control the engine speed);

4. Turn off the car and turn off the engine; Restore the throttle connecting pipe to its original state, restart the engine, idle for 3~5min, and then quickly accelerate for 2~3 times, and control the speed at 3000r/min.

Finally, theoretically, the fault code of the throttle can be cleared without disassembly and cleaning. If some students have a fault code after cleaning, they can directly unplug the battery negative line for 30 seconds and then connect it, without going to the 4S shop at all.