Paper carving course

1, detailed explanation of paper folding method in manual DIY paper carving lamp stamp. The first step is to dig a small hole in the middle. If you are not careful, you will make mistakes and have a big turning point. Don't cut at once, but connect several knives, or you will break the tip of the knife.

2. After all hollowing out, cut along the contour line of the edge. At this time, you can align the line with a steel ruler, scratch it with a meat cutter (this is easier to align, but it will slip if you can't hold the ruler with your hand), or you can cut it with scissors (if your hand is disabled, it is easy to cut, but the operation is simple).

3. Finally, replace the meat cutter with a needle and make a hole where it needs to be pierced. Poke gently, the small hole should be shallow and the big hole should be deep. Punch the hole at last, or it will be gone when you press the hole.

4. Stick butter paper where you need to stick butter paper, cut it along the outline and stick it with white glue, or stick the whole piece with double-sided tape without cutting it. However, double-sided tape will affect the light transmittance, so those with double-sided tape can only be attached to the farthest edge that will be blocked by the frame.

5. After all drawings are processed, assemble the plastic frame. After the four corners are installed, you can put them on the desktop to see if the four corners are on the same plane. Tear off the two layers of protective film of acrylic board and put it in the frame (remember to break off the small iron sheet for fixing around the frame before putting it in).

Then, according to the numbers in the lower right corner of the drawing, from small to large, the number is forward, the first one is placed near the acrylic board, and a plastic frame is placed behind it, and a drawing is placed. If there is more than one plastic frame, two frames are placed between the last drawing and the backplane.

6. Stick the lamp strip and the receiver on the backboard, connect the USB cable to the receiver after passing through the small hole, cover the receiver on the top, cover the lamp strip on the bottom, and then break the small iron sheet back to fix the backboard. If you want to hang it on the wall, you should install a fixing pin at this time. Stick four anti-skid pads on the bottom of the frame.