Running-in knowledge of fuel moped.

1. During the running-in period, fully open throttle and rapid acceleration should be avoided, and long-term continuous driving should be avoided. If you need to run a long distance, you should pay attention to proper rest and cool down the engine.

2. During the running-in period, it is recommended to change the oil for the first time at 300-500 km or 1000 km, depending on the vehicle instructions. If you use the vehicle in bad road conditions, you need to change the oil in advance.

3. Pay attention to the reasonable coordination of vehicle speed, engine speed and gear position during the running-in period to avoid low-grade high-speed or high-grade low-speed If you feel that the power is insufficient, you should downshift in time, and you can't forcibly increase the throttle.

The motorcycle warms up when it starts.

1, when starting the engine, slightly open and close the throttle, warm up for 3~5 minutes, and then confirm whether the engine idle speed is within the range specified in the manual.

2. After the engine is fully warmed up, drive at low speed 1 ~ 2km, and then drive at high speed.

3. When riding a bicycle in a cold state, be sure to open the throttle handle and close the throttle handle when starting until the engine runs smoothly.

Don't slam on the accelerator at high speed in neutral.

1, neutral high-speed throttle lever will accelerate the wear between engine parts and reduce the service life of the engine.

2. In severe cases, it may even cause accidental injuries such as valve collision, bending of connecting rod, combustion of crankshaft, eccentric wear of piston and ejection.