How to match Bora after washing the throttle?

The engine is warmed up to normal operating temperature.

1. Turn off the ignition switch and wait at least 10 second;

2. Ensure that the accelerator pedal is completely released, turn the ignition switch to the on position and wait for 3 seconds;

Repeat the following operations five times in 3.5 seconds.

A. completely depress the accelerator pedal,

B. completely loosen the accelerator pedal;

4. Wait for 7 seconds, fully press the accelerator pedal, and keep this state for about 20 seconds until the MIL stops flashing and starts to light up;

After 5.5 seconds, completely release the accelerator pedal within 3 seconds. The MIL light is turned on;

6. Start the engine and let it idle for a period of time;

7. Idle for more than 20 seconds;

8. Run the engine at high speed for two or three times, and make sure that the idle speed and ignition timing meet the requirements.

This program is very time-sensitive. You'd better use a stopwatch, or the light won't work.

Heat the car first, and the water temperature light will go out. After starting the power supply, the blue water temperature light goes out at the 3rd second, and the airbag light goes out at the 8th second. Turn on the power supply, and then the instrument lamp performs self-inspection. After the water temperature light goes out, step on the accelerator from 1 sec, and step on 1 sec. After stepping on it for 5 times, the airbag light will go out. This time should be accurate. You have to wait for 7 seconds to step on the accelerator for a long time, and keep pressing 10.