18 how to remove the throttle pipe of the new MG 6

18 the disassembly method of the throttle tube of the new MG 6 is to screw the throttle control mechanism to the maximum position, hold it with the left hand and the throttle cable with the right hand, and take it out from the gap of the control mechanism. Then remove the cable from the accelerator cable bracket, remove the limit clamp and gasket, and put them in a safe place for safekeeping. Finally, remove the accelerator cable bracket fixed on the accelerator body.

Maintenance of MG 6

Cleaning solution is irreplaceable by carburetor and other cleaning agents. Instead, you should buy a special accelerator cleaner to prevent the accelerator from being corroded in the future. Just unscrew the fixing screw of the air filter box, and the cover can be removed. Do not unscrew it to prevent the screw from falling into the engine compartment and being lost. All open pipes should be covered to prevent dust or sundries from entering. Do not operate in windy or windy places to prevent dust.

When cleaning, turn the throttle gently to prevent the throttle from deforming or losing its elasticity. The air filter box needs to be installed and reset in place, so firmly press the ball button below and put all the pipes back. Finally, check them one by one to prevent omissions. After cleaning, it is best to use 5053 for computer matching if possible.