Rotary clamping cylinder

The initial state of this cylinder should be that the piston rod is extended, generally to avoid the installation position, so it should be said to rotate 70 and then press down. Why is 70 so high? In fact, you can buy a general rotary press cylinder, also called a jig cylinder, which has enough height below to reach the position of the workpiece you need to press. If you just press a workpiece without interference, you can use the 70 you want. Cylinders whose piston rods are not milled flat are equipped with circular contact pressure plates. You can rotate the initial position of its pressure plate to your pre-tightening position at any time, which means that you can move the relative position of 90 as a whole. At present, there are just a lot of 90 spinning on the market, but not many 70 spinning. If the quantity is not too much, you can do it completely. Of course, if you have a large quantity, you can choose to redesign it. There is no problem with the height and rotation angle you want, and both can be solved. If you have any other questions, you can send an email to Yang Jiajun _89@ 163.com and we can discuss it!