How to clean Santana throttle

If there is too much sludge in the accelerator, it may cause poor engine acceleration and increase fuel consumption, which is a big worry for the owner. What should I do if the throttle is dirty? Just clean it up Go to the 4S shop, the throttle will be repaired soon, but don't you have to go to the 4S shop to clean it every time? Actually, you don't have to. You can handle it yourself. Just don't forget to initialize. First, apply a little oil on the fixed metal beam ring to avoid slipping teeth during disassembly. [1] Remove the metal collar of the throttle hose. After the hose is removed, the left end is the position of the throttle. Remove the negative electrode of the battery, turn off the ignition switch, straighten the throttle plate, spray a small amount of "carburetor cleaner" into the throttle, and then carefully scrub it with polyester rag or high-spin "non-woven fabric". Deep in the throttle, you can clamp the rag and scrub it carefully where your hands can't reach it. When cleaning the throttle valve, it is not necessary to disassemble it, but the sealing part of the inlet steam must be cleaned, and the idle motor must be disassembled for cleaning. There are advantages and disadvantages of cleaning nozzles by borrowing and disassembling. Generally speaking, the maintenance station suggests disassembling and washing, which can prevent other unnecessary waste, such as replacing the sealing ring after disassembling, installing other gaskets, or delaying the owner's time because of oil and gas leakage when disassembling. [2]