Does Corolla 12t need a computer reset to clean the throttle?

Corolla 12t cleaning throttle does not need computer reset, just disconnect the battery line for one minute, and the matching can be successful. The method of resetting and initializing the throttle of Toyota Corolla is to turn the key to the second gear, that is, the gear where the instrument indicates full light. Then wait for 20 seconds, then step on the accelerator to the end and keep it at about 10s, then release the accelerator, turn off the ignition switch, pull out the key, and the initialization is complete.

Throttle is one of the most important components in EFI automobile engine system. Its upper part is the air cleaner grille, and the lower part is the engine body, which is the throat of the automobile engine. Whether the acceleration of a car is flexible or not has a lot to do with the dirt of the throttle. Cleaning the throttle can reduce fuel consumption and make the engine flexible and energetic.

Matters needing attention in cleaning throttle valve

Apply a little oil to the fixed metal beam ring to avoid slipping teeth during disassembly. Remove the metal wire harness ring of the throttle hose. After the hose is removed, the left end is the position of the throttle. Remove the negative electrode of the battery, turn off the ignition switch, straighten the throttle plate, spray a small amount of carburetor cleaner into the throttle, and then carefully scrub it with polyester rag or high-spinning non-woven fabric.

Deep in the throttle, where the hand can't reach, you can clip a rag and scrub it carefully. When cleaning the throttle valve, it is not necessary to disassemble it, but the sealing part of the inlet steam must be cleaned, and the idle motor must be disassembled for cleaning. Nozzle borrowing cleaning and disassembly-free cleaning have their own advantages and disadvantages. Generally speaking, the maintenance station suggests no disassembly and cleaning to prevent other unnecessary waste.