The process of balloon folding small animals

The balloon folding animal tutorial is as follows:

1. First, inflate the balloon until a small tail of about 5 cm remains.

2. Three continuous single bubble knots. The first paragraph is almost 5 cm long and will be used as a puppy's nose. The second and third paragraphs are relatively small, almost 2.5 cm long, and act as the ears of the puppy. Pay attention to these nodes by hand, so that the balloon will not spread out.

3. Bend the remaining longest part side by side with the first short segment, and the bending point is located between the second short segment and the third short segment, so as to carry out the "interlocking twist" in our basic movements.

4. Release the right hand after twisting. Your balloon should look like a dog's head.

5. Above the dog's head, follow three "basic twists" to form three ABC parts, each about 8 cm long. Section A should be the neck of the puppy, and section BC should form the front leg of the puppy. Remember to hold all these parts by hand, or they will fall apart.

6, now the balloon, you can see the first half of the puppy, head, neck, front legs. The hand-held part is the remaining unwound balloon. Continue to have more than three "basic twists" to form ABC three sections, each saving 8 cm in length. Section A should be the puppy's body, section BC should be the puppy's hind legs, and the remaining section D should be the puppy's tail.

7. Tidy up, and you will see a puppy finally twisted.

Make the puppy's body longer and legs shorter to look like a dachshund; Use a yellow magic balloon, and then leave the neck part very long to look like a giraffe; You can also leave your neck very short and your legs a little longer, and you can say that it is a horse.