What is the manual matching method of 14 VIOS throttle?

Pacific Auto Network 1, turn the key to the power gear first, and never start the car, that is, the engine is turned off. 2. After standing for about 15 seconds, quickly step on the accelerator pedal to the end, be sure to step on it quickly, hold on for 15 seconds, and then quickly lift the pedal. 3. Then close the key door, take out the key and let it stand for about 15 seconds. 4. Start the car normally and complete the matching.

Matching method:

1, turn the key to the power gear first, and never start the car, that is, turn it off.

2. After standing for about 15 seconds, quickly step on the accelerator pedal to the end, be sure to step on it quickly, hold on for 15 seconds, and then quickly lift the pedal.

3. Then close the key door, take out the key and let it stand for about 15 seconds.

4. Start the car normally and complete the matching.

Nowadays, most Toyota cars are electronic throttles, which will lead to low idle speed, engine jitter and easy flameout if they are used for a long time. At this time, it is definitely time to wash the throttle, but after washing the throttle, the idle speed will be too high. Most people will solve the problem by removing the battery and pulling out the fuse, but there will also be other problems, such as the setting of windows, skylights, clocks and directions. The method used here is different from everyone else. The method is as follows: After the accelerator is washed, skip the 4# and 13# feet of the diagnosis seat, go out and run for 10 minutes, and the fault light flashes all the time. When you come back, take off the jumper and start the idle speed, and the idle speed learning method of Toyota electronic throttle will be normal.

1, turn off the ignition switch,

2. Unplug the EFI and ETCS fuses in the engine compartment fuse box, and put them back in place after 1 minute, and the idle learning is completed.

(Photo/Text/Photo: Pacific Auto Network Q&A called Beast)