How to Clean Throttle by Nissan Sunshine How to Clean Throttle by Nissan Sunshine

The cleaning method of Nissan Sunshine Throttle is as follows:

1. Preparation tools: 8mm sleeve (high utilization rate, necessary), pliers, ratchet wrench, offset sleeve and adapter rod. The main tools used are 8mm sleeve, detergent and a bottle from 8 yuan.

2. Open the engine compartment and loosen the clamp on the air intake hose with an 8mm sleeve (hereinafter referred to as sleeve).

3. After loosening, open the two metal clips on the air cleaner by hand (be careful not to fall into the engine room), open the air cleaner cover, and then slowly unplug the air inlet hose.

4. Loosen the clamp with pliers, and unplug the thickest and shortest hose in the center of the figure, with the lower end close to the oil filler and the upper end close to the air filter waste oil and gas collector.

When you pull it out, you can transfer a bunch of things from the air cleaner to the side of the water tank, and there are some other connecting wires, so you don't have to break them, just take them with you. At the same time, the upper sleeve began to loosen the four bolts that fixed the throttle valve (to avoid falling into the engine room).

5. Well, the throttle is finally separated (don't unplug the connecting cable on the throttle, or the computer will need to be matched again). The following is to spray, wipe, spray and wipe with cleaning agent. At this point, there is no need to disconnect all the connecting wires on the throttle, remember!

6. Finally, just put it back according to the previous steps.