Traditional Culture Encyclopedia - The 24 Solar Terms - Where is the Jetta electronic fan relay?
Where is the Jetta electronic fan relay?
Jetta electronic fan relay is in the fuse box in the front engine compartment. The working principle of electronic fan is that the automobile electronic fan is controlled by thermostat. When the water temperature rises to the upper limit, the thermostat turns on the power fan and starts to work. When the water temperature drops to the lower limit, the thermostat turns off the power fan and stops working. The following are the reasons why the electronic fan does not turn: 1, the motor is poorly lubricated and cannot be dragged after the fan blade is installed; 2. Overheating of the motor Overheating of the motor will also cause the load capacity of the motor to deteriorate, and the effective power of the motor will become lower, resulting in the inability to drive the load; 3. When the starting capacitor capacity becomes smaller, the capacitor capacity will become smaller, resulting in a smaller starting torque of the motor and inability to drive the load; 4. The motor is used for a long time. If the electric fan is used for a long time, the motor will wear out, and the shaft sleeve of the motor will be easily burned out after wear. Long-term use of the motor will also increase the internal resistance of the motor and decrease the load capacity, resulting in the inability to drive the blades to rotate.
- Previous article:Where is the car throttle?
- Next article:Solar term network celebrities
- Related articles
- 20 13 Buick LaCrosse 2.4 wobbled after ignition and just ran 2700 kilometers.
- Buy Moutai at the price. Does A's behavior constitute fraud?
- Solar term font modeling
- How to describe the scenery in spring?
- What traditional foods do millennials eat?
- Stand on tiptoe to see the stars.
- Which software is good for beauty camera?
- What are the dietary taboos of Xiaoman solar terms?
- Which gifts are more suitable for friends from winter solstice?
- Do you need air intake when adjusting the limit screw of pneumatic valve?