How to match the throttle of Nissan Teana?

Nissan Teana's throttle matching method is as follows:

1. Turn the ignition switch to on after the flameout.

2. Press the accelerator quickly after about 3 seconds, and make sure to release the accelerator pedal 5 times within 5 seconds.

3. Then wait for about 7 seconds without moving anything, and then step on the accelerator.

4. After continuously pressing the accelerator pedal for about 10 seconds, the engine fault light on the clock will flash and then remain on. At this point, the throttle matching has been completed, just release the accelerator pedal.

Extended data:

Cleaning and installation method of throttle valve and matters needing attention

1, disassemble and clean. When disassembling, pay attention to apply some oil on the fixed metal beam ring to avoid slipping teeth in the process. Remove the metal ring and hose of the throttle hose, and the left end is the throttle. Remove the negative electrode of the battery, turn off the ignition switch, straighten the throttle plate, spray a small amount of "carburetor cleaner" into the throttle, and then carefully scrub it with polyester rag or high-spin "non-woven fabric". If you can't reach it, you can wipe it with a rag.

2. Installation method. After cleaning, it is necessary to initialize the throttle after being installed according to the disassembly procedure just now (initialization is necessary). This is because there is sludge blockage before cleaning. In order to ensure the air intake, the computer will automatically adjust the throttle opening to make the air intake in a normal state. If the previous opening is maintained after cleaning, the intake air is too large, which will lead to engine jitter and weak acceleration when starting.