BMW b48 Camshaft Solenoid Valve Location

Loosen the screws at two places: 1 and the screw at the air inlet with a flat screwdriver until it can be pulled out (upper left ring). 2. The second position is below the lower right ring. After loosening the port on the throttle, pull the degumming tube with a little force, then lift the large box and take it off ... For more information about the position of the solenoid valve of BMW b48 camshaft, the engine will idle for 2 seconds. It seems that the intake electromagnetic BMW 320 and B48 engines, after the valve cover is replaced, the exhaust solenoid valve of VANOS is stuck, sometimes the intake is stuck, and sometimes both are repaired at the same time. After removal and cleaning, it was reported that the exhaust solenoid valve could not be in place and the timing delay of the camshaft position actuator was too large (group 1).