How to disassemble and assemble Honda Crown Throttle?

Dismantling method of Honda Crown Throttle: First, circle the fixed metal bundle with a little oil to avoid tooth slipping during disassembly. Remove the metal ring of the throttle hose. After the hose is removed, the left end is the position of the throttle. Take off the negative electrode of the battery, turn off the ignition switch, straighten the throttle, spray a small amount of "carburetor cleaner" into the throttle, and then carefully scrub it with polyester rag or high-spinning "non-woven fabric" and go deep into the throttle that you can't reach. Hold the rag and scrub it carefully. When cleaning the throttle valve, it is not necessary to disassemble it, but the sealed part of the inlet steam must be cleaned, and the idling motor must be disassembled before cleaning. Borrowing and cleaning syringes has advantages and disadvantages. It is generally recommended that the maintenance station should not disassemble and clean to prevent other unnecessary waste, such as the need to replace the sealing ring or install other gaskets after disassembly, or the phenomenon of oil leakage during disassembly and assembly, which will delay the owner's time. After cleaning, follow the disassembly procedure just now, and start the initialization of the throttle valve after installation. It needs to be initialized after cleaning the throttle, because the computer has a memory function when adjusting the throttle opening. Because there was sludge blockage before, in order to ensure the air intake, the computer will automatically adjust the throttle opening to keep the air intake in a normal state. Honda Crown Throttle Matching Method: 1. Computers match, but some models can't match. 2. Find the power failure of the throttle fuse or the negative battery. Step on the brakes for a few minutes or go out for a run. Basically, normal idle speed can be restored.