How to solve the Fit fault code p0 172?

Fit fault code: p0223 is described in detail as follows: System fault range: None at present.

Applicable models: Fit

P0223: Throttle position sensor B circuit voltage is too high

English meaning: Not at present.

P0223 fault code knowledge:

no

Causes and effects of failure:

Suggestions and solutions: 0 1 Turn the ignition switch to the on(ii) position. Use hds to clear the DTCs. Use hds to check throttle position sensor B in the data sheet. Is it around 4.8v or higher? Yes, go to step 04. No, intermittent failure. At this point, the system is normal. Inspect the throttle body and the engine control module/powertrain control module for poor contact or loose terminals. Use hds to check temporary DTCs. Are dtcp0 123 and p0223 displayed at the same time? Yes, go to step 13. No, go to step 05. Turn the ignition switch to the lock position. Disconnect the 6-pin connector of the throttle body. Turn the ignition switch to the on(ii) position. Measure the voltage between terminal 3 of throttle body 6-pin connector and body ground. Is it about 5v? Yes, go to step 18. No, go to step 09. Turn the ignition switch to the lock position. 10 uses hds to cross scs line. 1 Disconnect the ECM/PCM connector c(49 pin). 12 Check whether there is continuity between terminal c2 1 of ECM/PCM connector and terminal 3 of 6-pin connector of throttle body. Is it open? Yes, go to step 25. No, repair the open wire harness between ecm/pcm(c2 1) and throttle body, and then proceed to Step 20. 13 Turn the ignition switch to the lock (0) position. 14 Disconnect the 6-pin connector of the throttle body. 15 crossing scs line with hds. 16 Disconnect ECM/PCM connector c(49 pins). 17 Check whether there is continuity between terminal c43 of ECM/PCM connector and terminal 4 of 6-pin connector of throttle body. Has it started? Yes, go to step 25. No, repair the open wire harness between ecm/pcm(c43) and throttle body, and then proceed to Step 20. 18 Turn the ignition switch to the lock (0) position. Replace the throttle body. 20 Reconnect all connectors. 2 1 turn the ignition switch to the on(ii) position. 2 Use hds to reset the engine control module/powertrain control module. Perform the engine control module/powertrain control module idle learning procedure. 24 Use the hard disk to check the temporary DTC or DTC. Is dtcp0223 displayed? Yes, check the throttle body and the engine control module/powertrain control module for poor contact or loose terminals, and then go to Step 0 1. No, the troubleshooting has been completed. If other temporary DTCs are displayed, go to Troubleshooting to display the DTCs. 25 Reconnect all connectors. If the software version of the engine control module/powertrain control module is not the latest, please update or replace it with a known-good engine control module/powertrain control module. 27 Use hds to check temporary DTCs or DTCs. Is dtcp0223 displayed? Yes, check the throttle position sensor B and the engine control module/powertrain control module for poor contact or loose terminals. If the ECM/PCM has been updated, replace it with a known-good ECM/PCM and recheck it. If the ECM/PCM is replaced, go to step 0 1. No, if the ECM/PCM has been updated, the troubleshooting has been completed. If the engine control module/powertrain control module is replaced, replace the original engine control module/powertrain control module. If other temporary DTCs are displayed, go to Troubleshooting to display the DTCs.

Million car purchase subsidy