Traditional Culture Encyclopedia - Traditional culture - How to convert traditional fluorescent lamps into led lamps
How to convert traditional fluorescent lamps into led lamps
For safety reasons, first turn off the main switch of the home circuit, now the lamp has two installation methods, the first installation method is the old installation method, that is, there are springs on both sides of the side, with a little force to one of the side to push a little bit can be out of the installation of the marquis is also the same way, will be the lamp on one side of the two terminal blocks (also known as the wiring pins or needles) against the two holes in the socket on one side, press a little force to one side, the lamp can be mounted on the side. One side of the socket of the two holes, and force to one side of the press, the lamp can be mounted.
The second type of installation is twisted, that is, both sides have a Feng, the lamp to follow the gap put in, and then twisted half a week, you can card the lamp. Know these 2 kinds of lamp installation can easily remove him out, if your home lamp is the first installation, as long as one hand holding the lamp to one end of the force push a little, can be easily removed, if it is the second installation, it is even simpler, as long as the lamp rotated half a circle, so that the lamp's wiring pins are exactly aligned with the mounting slit of the lamp bracket, it can be easy to remove the lamp.
2. Remove the bracket cover
Commonly used bracket cover there are two kinds, one is the cover directly press the base plate, for this cover we can left hand press the base plate, the right hand to hold the cover to pull up, you can remove the cover, there is also a kind of screws to lock the cover plate in the base plate, this direct screwdriver to unscrew the screws can be removed.
3. Remove the electronic ballast
Electronic ballast input connected to the power grid, electronic ballast output connected to the ends of fluorescent lamps, with diagonal pliers to cut the input and output lines of the electronic ballast, and a screwdriver to fix the electronic ballast screws out can be easily removed electronic ballast.
4. Wiring
Use wire strippers to strip the wires of the grid and the bracket port inlet wires, exposed copper 3CM in order to connect the wires, the wires of the grid and the bracket port inlet wires and wrapped with electrical tape
5. Cover the cover
The wrapped wires straightened out and secured to the bracket groove, with both hands hold the cover, and pressed down hard to be covered with a cover. cover plate.
6. Installation of LED lamp
The LED lamp ends of the wiring pins aligned with the bracket mounting slits, it can be easily put in, and then twisted half a circle, the LED lamp is installed, and now complete the replacement of the LED lamp
The above method by the BaoDaHaoNan.com, remember to pull off the electric switch to ensure safety when changing the lamp.
- Related articles
- Inheritance of Wang Peiyu's Traditional Culture
- Local Culture: Ningdu Horse Lantern Dance
- From what aspects should the appreciation of ancient poetry be answered?
- Dear gods, give me an inventory of the shocking events of 20 12.
- What are the specific applications of drones in surveying and mapping
- China ancient 72 lines are those?
- What is a pineapple pizza?
- How much firepower gas stove is suitable for buying?
- How to make a good speech at the conference on attracting investment in the development and reform system
- Many people like Hanfu now. Hanfu was the costume of which dynasty in China?